Business Links
LRFD Bridge Design Manual
This Manual contains NDDOT Bridge Division
policies and procedures for the design, evaluation, and rehabilitation of bridges. Except where noted, the design provisions herein employ the Load and Resistance Factor Design (LRFD) methodology set forth by AASHTO.
Use of this Manual does not relieve the design engineer of responsibility for the design of a bridge or structural component. Although Bridge Division policy is presented here for numerous situations, content of the Manual is not intended to be exhaustive. Therefore, use of this Manual must be tempered with sound engineering judgement.
- LRFD Bridge Design Manual Cover

- Table of Contents

- Chapter 1 - Introduction

- Chapter 2 -General Design and Location Features

- Chapter 3 -Loads And Load Factors

- Chapter 4 -Structural Analysis And Evaluation
- Chapter 5 -Concrete Structures

- Chapter 5b - Design Examples

- Chapter 6 - Steel Structures

- Chapter 6b - Design Examples

- Chapter 7 - Reserved (Aluminum Structures)

- Chapter 8 - Reserved (Wood Structures)

- Chapter 9 - Decks And Deck Systems

- Chapter 9b - Design Examples

- Chapter 10 - Foundations

- Chapter 11 - Abutments, Piers, And Walls

- Chapter 12 - Buried Structures

- Chapter 13 - Railings

- Chapter 13b - Design Examples

- Chapter 14 - Joints and Bearings

- Chapter 14b - Design Examples
